24V Cordless Lawn Mower Owners Manual

ASSEMBLY
Unpack and remove the whole unit from packaging, and ensure all the parts are present.(See Figure 1)

1. Set the cutting height to the highest setting. This will make it easier to attach the lower handle section
2. Fit the Lower handle onto the two large lugs on the Main Unit. side and then flex the other side of the handle until it fits the opposite lug. (See Figure 2)
3. Assemble the Upper Handle to the Middle Handle. Use 2 sets of the nuts and bolts to secure in place. Make sure that when the Upper Handle is facing up (safety button facing up) If you have incorrectly assembled this part,disconnect and re-assemble in the correct orientation. (See Figure 1)
4. Use 2 sets of the nuts and bolts to assemble the Upper and Middle Handle assembly to the Lower Handle. The nuts should be positioned on the inside of the handle and the bolts on the outside. (See Figure 4)
5. Once the Handle is assembled connect the plug on the handle cable to the socket on the main unit. Tighten the screw ring to secure the cable. (See Figure 5)
6. Secure the cable to the handle using the clips.(See Figure 6)
7. Attaching the Grass Catcher to the Mower Base Note:This mower can be used with or without grass catcher.
   Step 1: Place the 2 Grass Catcher side bar hooks Reel Mower as shown in onto both sides of the Grass Catcher Hooks on both sides of the Grass Catcher Hooks on back of Reel Mower as shown in Figure 7.
   Step 2: Wrap the Security Belt, located on the back the grass catcher, around the center joint of the Lower handles and lock buckle into place, as shown in Figure G (also refer to figure on front cover for reference if needed).Note the length of the Security Belt can be adjusted by modifying the Security Belt Length Adjustment Loop. (Figure

BATTERY CHARGING AND RECHARGING
Before First use charge the battery for 24 hours

The battery does not have to be removed from the product to be charged. To charge the battery in the product, and plug the charger connector onto the battery socket.

For external charging, first turn the knob on the battery lid counter-clockwise then raise the handle and lift battery out of the machine. Place the battery on a flat, non-slip surface, and plug the charger connector onto the battery socket, charge the battery for 24 hours each time.

To refit the battery, lower it into the cavity on the top of the product in the correct orientation. Ensure the handle is pressed down and then turn the knob on the lid clockwise. If the battery does not fit correctly remove it and check there are no obstructions.

Download file here