Apple Video iPod Audio/Video Interface Manual

Installation

• Gain access to the back of you vehicle’s Head Unit.
• Find the same port as our Audio Harness (see “Connecting SoundLinQ2 to head unit”)
• Disconnect the existing connector and plug in our Audio connector into this port, then plug female end of Audio
• Harness to the plug in for your factory connector. Audio harness female connector is not used In some vehicles.
• Plug the other end of Audio cable into designated port on SoundLinQ2.
• Connect iPod cable as shown in the”Connecting SoundLinQ2” picture.
• Setup proper Emulation Mode for this unit (see “Emulation Mode Selection”)
• Turn the car on and check SoundLinQ2 functionality and (especially Text capability) before the final assembly.
• Make sure your iPod has at least two playlists, in order for this unit to operate properly.
• Please mount this unit in easy accessible location for upgrading and re-programming purposes.
• Secure the Head Unit in its original position.

Emulation Mode Selection

MD Changer Emulation Mode programming steps:

• Properly install this unit.
• Put both programming switches in “DOWN” position.
• Put ignition switch into “ACC” position.
• Wait for long beep followed by a few short beeps. This take up to one minute.
• Return programming switches into their default position (both switches “UP”).
• Wait up to 30 seconds until confirmation beep.
• Put ignition switch into the “OFF” position. Wait at least 10 seconds.
• Put ignition switch into “ACC” position.
• Check SoundLinQ2 for functionality, especially TEXT capabilities.

CD Changer Emulation Mode programming steps:

• Properly install this unit.
• Put “Right” programming switch in the “DOWN” position.
• Put ignition switch into the “ACC” position.
• Wait for long beep followed by a few short beeps. This may take up to one minute.
• Return programming switches into their default position (both switches “UP”).
• Wait up to 30 seconds until confirmation beep.
• Put ignition switch into the “OFF” position. Wait at least 10 seconds.
• Put ignition switch into “ACC” position.
• Check SoundLinQ2 for functionality, especially TEXT capabilities.

Right-click here to download PDF version