Chevrolet Silverado Power Step Installation Guide
TOOLS REQUIRED
- Safety goggles
- Measuring tape
- Flat blade screwdriver
- Power Drill
- 9/32” drill bit
- 13 mm socket
- 10 mm socket
- Ratchet wrench and extension
- 13mm end wrench
- Wire crimpers
- Wire stripper / cutter
- 3/16” hex key wrench (allen wrench)
- 5mm hex key wrench (allen wrench)
- 4mm hex key wrench ( allen wrench )
- Electrical tape
- Weather proof caulking (silicone sealer)
- Silicone spray
INSTALLATION GUIDE
- Steps 2-3 for HD 2500 and 3500 only! For all other vehicles skip to Step 4. Short Bed: Step 2 only, Long Bed: Steps 2 and 3.
- Remove forward most brake cable guide and replace with new guide (6).
- Install plastic brake cable guide (7) in rear of middle body mount. Install new parking brake cable guide (24) in existing frame hole as shown.
- Install threaded clamping plate (13) on top of pinch weld and thread fastener ( 10) into clamping plate and torque to 16 ft-lbs. (22 N m). Next install fastener (12), fi nger tighten only.
- Install driver side rear motor linkage in fourth sheetmetal tab / hole from front (Crew Cab). Linkage will then clear parking brake cable.
- Slide mounting T-nut into position, aligning the end of the board with the rear edge of the back door. Mount board and tighten fasteners to 10 ft-lbs. Insure linkages are squared to body prior to torquing fasteners.
Download file here
Incoming Search Terms : instalation power step silverado
