Cisco SCE 2000 4xGBE Installation and Configuration Guide
Introduction
This preface describes who should read the SCE 2000 4xGBE Installation and Configuration Guide, how it is organized, and its document conventions.
This installation guide explains the initial hardware installation and basic configuration procedures for the SCE 2000. It contains procedures for unpacking and installing the device and performing basic configuration via the setup wizard. After completing the installation and basic configuration procedures covered in this guide, you will then use the appropriate companion publications to more completely configure your system.
This guide contains instructions on how to install and run the SCE 2000 platform. This guide assumes a basic familiarity with telecommunications equipment and installation procedures.
Audience
This guide is for the networking or computer technician responsible for installing and configuring the SCE 2000 platform on-site. To use this publication, you should be familiar with telecommunications equipment and installation procedures, as well as electronic circuitry and wiring practices. You should also have experience as an electronic or electromechanical technician.
CHAPTER 1 – General Overview
Introduction
This chapter provides a general overview of the Cisco Service Control solution. It introduces the Cisco Service Control concept and the Service Control capabilities.
It also briefly describes the hardware capabilities of the Service Control Engine (SCE) platform and the Cisco specific applications that together compose the total Cisco Service Control solution.
- Information About the Cisco Service Control Concept, page 1-1
- Cisco Service Control Capabilities, page 1-2
- The SCE Platform, page 1-3
- Information About Management and Collection, page 1-4
Download file here
