LEDayLine Daytime Running Light Installation Guide

The relay provided is used to interrupt the voltage supply to the daytime running lights when the vehicle’s main lights are switched on. The relay is, therefore, fitted between the lights and the voltage supply.

When the position (side) light is switched on, voltage is supplied to the relay coil, which opens the circuit and interrupts the power supply to the daytime running lights. For this, the relay requires a respective signal, which is simply taken from the main headlight plug with the aid of a splice connector and fed to the relay. The cable of the standard position light must be used for this (terminal 58). At this point, route all cables to the relay and connect according to the Hella circuit diagram in the instructions.

Tip: Test the function of the daytime running lights now, as any problems are easier to eliminate at this stage.

Now insulate the individual cables of the circuit and route them in such a way that no damage can occur.

While cable routing to the left-hand daytime running light is straightforward, it is recommended that the cable to the driver-side be routed through the bulkhead. The harness provided by Hella easily allows for this. Use the original vehicle harness and its route as a guide and use cable ties to secure everything into place.

Download file here

Incoming Search Terms : Daytime Running Light Installation, daytime running light, daytime running light instalation instructions, daytime running lights installation, location of drl module intrepid