VW Jetta A5 Limousine RHD 13-pin Installation Kit
Package includes:
1 Socket cable set, 12-core with pre-assembled socket
1 8-core cable set for connection to the on-board electrical system
1 Cable set, 3-core for connection to the power supply
1 Trailer connection unit
1 13-pin socket incl. fitting material
3 Flat pin fuses 15 A
1 Cable ties 300 mm long
15 Cable ties 150 mm long
General procedure:
• Install electrical kit
• Fit socket
• Connect trailer connection unit
• Check operation
Note
When fitting, pay particular attention to the following points:
• Wiring must not be pinched or damaged.
• All seals must be properly seated.
• The seal for the socket must be positioned on the insulating sleeve and not on the individual wires.
• Route wiring so that it does not chaff against the vehicle or break off.
• Do not route wiring immediately next to the exhaust system.
Failure of a trailer light (also the indicators, not reversing light and rear fog light) is shown by the lamp failure indicator on the instrument panel. There is no additional warning lamp (C2) in the vehicle for checking the turn signal indicators on the trailer. For trailer operation the rear fog light of the towing vehicle is disabled. A rear fog light must be retrofitted on trailers not already equipped with one. A socket adapter may only be used in trailer operation. Remove the socket adapter when trailer operation is not in use. Check the operation of the trailer using a trailer or test equipment with load resistances. Technical changes reserved!
Download file here
